Let’s learn how to use an electric winch in this article.
Electric winches are used on 4X4 cars and ATVs to retrieve them from deep mud pits or tight spots.
The difference between spending a wonderful afternoon in a remote place and a long trek to the nearest phone is all in how well you handle the winch.
Use a winch that is rated appropriately for the task. A decent rule of thumb when selecting a winch for your car is to overrate it by 1.5 times.
In other terms, if the car weighs 5000 pounds, use a winch with a pulling capacity of 7500 pounds.
So how to use an electric winch? Let’s find it out.
Also check: Best electric winch
How to Use an Electric Winch
Before settling on an Electric Winch-pulling strategy:
- Assess the scenario.
- Take your time to weigh all of the choices for getting the vehicle out of the issue.
- Inform everybody who is with you about the plan you have devised.
- Inform them of the location of chains and cables that will be used to pull the car from its current location to a free and safe space.
When working with metal cables or chains, always use leather gloves. The wires inside the winch rope can easily tear and puncture exposed skin, causing holes.
Never rub your fingers over the metal cables, gloves, or bare. Clear as much debris as feasible from the front of the tires using the hand shovel.
Construct a slope that travels outward in the pull area from the stopped position. Clear any large rocks or uprooted trees that may have fallen into the path.
Wrap the 12-foot rope around the body of any sturdy pulling structure to secure it. To preserve the bark of living trees, place a 5-foot square rubber pad under them.
Wrap the rubber pad around the tree trunk’s underside. The chain should be looped around the base of the tree. The rubber pad should be placed between the bike chain and the tree.
Attach the chain to the winch’s wire hook. Before putting any pressure on the winch wire, make sure there are at least 3 full wire rounds on the drum.
Use the 25-foot extension lead with the collet hooks if the wire is too low. Keep everyone away from the cable pulling the winch’s direct path. Draw a straight line through the winch on its own to free the vehicle.
Pulling the vehicle at an inclination is not a good idea. The rope must be able to neatly place itself onto the winch drum in even “lays.” Allowing the cable to swell up or ride in front of itself is not a good idea.
If the cable enters the winch at an angle, proceed to the following step to adjust the pull angle. Connect the 5-ton grab block to the secondary rubber mat and 12-foot chain to draw the car in a straight line.
Use the chain and adhesive mat to attach the grab block to a second tree in the same way as in the third step. Put the winch cable through the grab block pulley to be dragged straight into the winch drum.
By giving a straight line into the winch drum component, this snatch block system can be used to release any vehicle.
Looking For Other Electric Winch Guides?
Featured Other Type of Electric winch Reviews
Electric Winch Guides
Conclusion
An electric winch is a dragging or pulling tool with a drum wrapped in rope, wire, or chain that can be operated by hand or an engine.
An electric winch can be quite useful if you do a lot of off-road driving or live in a harsh climate.
A winch bumper substitutes a standard front bumper with a heavy-duty bumper that can hold a winch.
When placing an electric winch on your car, a winch bumper replaces the requirement for a winch plate.
Because these bumpers are car-specific, contact your car maker to find out where you can get an aftermarket winch bumper produced for your vehicle.
